u/NoPLSNoStopWhy

I am losing my mind from this darwinfpv f405 stack, was just about to hover test the drone but it kept flipping out. Checked the setup 3d model and just realized this. I have been trying to figure it out since morning and it still won't budge, I've tried changing board orientation and checking board arrow but no change. Does any of you ever have this same problem or maybe have a fix?

Was soldering something on the jhemcu ghf435 board and accidentally "bumped" into the small resistor next to it. As far as i know that resistor is used for a voltage divider? Since after i looked into it that's what came up. I've tried turning on the quad and the voltage does read 0V. So I'm wondering, does it only affect the voltage reading or will it affect anything else that i may not know about?