u/NoeeeB

Hey,

I need micro-soldering tips :

I'm currently working on bending my kodak zd710, and after doing many effects with the adc pins, I wanted to do a last short on the sensor pins. Those are very small and I tried many time to get my 0.1mm enameled wire fixed on the pins. I managed to get 1 but it came off as I was trying the 2nd one next to it (you can see the evolution on the photos..)

Does anyone have tips wich can help me solder these?

PS : This sensor ribbon is the only ribbon I can't take off it's support for some reason, I'm not sure which side to pull on lol..

Hey,

I need micro-soldering tips :

I'm currently working on bending my kodak zd710, and after doing many effects with the adc pins, I wanted to do a last short on the sensor pins. Those are very small and I tried many time to get my 0.1mm enameled wire fixed on the pins. I managed to get 1 but it came off as I was trying the 2nd one next to it (you can see the evolution on the photos..)

Does anyone have tips wich can help me solder these?

PS : This sensor ribbon is the only ribbon I can't take off it's support for some reason, I'm not sure which side to pull on lol..

Hey,

I'm new in circuit bending and I'm just begining my 2nd camera (i broke the 1st one), and it's a kodak easyshare zd710. Even after doing some research, tests with a multimeter and else, I can't manage to understand how to find pins to short and especially how to know it can be a good pin to short (because I saw a lot of warnings about not shorting randomly obvioulsy).

Anyone has tips? Here's the photo of the PCB, the left connector contains the sensor pins I guess.

What am I looking for ?