u/NotSuiram

Body:

I’m planning an M2 Grate build and want to use a full ATX PSU instead of SFX. I modelled it in Fusion 360 and it looks like it should fit with a custom mount, but I’d like a sanity check.

My build: mini-ITX motherboard, full ATX PSU (150 x 140 mm footprint), Gigabyte RX 9060 XT 16GB (281 x 118 x 40 mm).

The photo: it shows a mini-ITX board with an SFX PSU and an RTX 4080 Super Trinity (306.8 mm long, about 2.5 slots) as a placeholder. My real card is shorter and thinner, so it should have more room.

Does anyone think the ATX PSU will fit, or has anyone tried it? Thanks!

Note: that this is the same layout im going for

https://preview.redd.it/n6vj67akbpuh1.png?width=722&format=png&auto=webp&s=58ad5b144052e87f214cb77275b9e0f8f2e89459

Hey i saw this youtube video from optimum where this was the layout the bottom two fans are outtake the gpu is on the top sucking air into the case and the fan on the side is outtake there all 140mm p14 pro pst.

I'm setting up a Tongsheng TSDZ8 mid-drive with an display havent decied on wich to get. From what I understand, most UART displays have one shared max-speed setting that applies to both PAS and throttle together.

Is there any way — through display firmware, hidden menu options, or open-source firmware — to set PAS and throttle to two different speed limits independently? Or is this a hard limitation of the stock UART protocol/controller?

Curious if anyone's tried this on a TSDZ8 specifically, or if it's only possible with fully custom/flashed firmware. Like or on any displays that fit with this motor

Thanks!

I'm setting up a Tongsheng TSDZ8 mid-drive with an display (havent deciede on wich). From what I understand, most UART displays have one shared max-speed setting that applies to both PAS and throttle together.

Is there any way — through display firmware, hidden menu options, or open-source firmware — to set PAS and throttle to two different speed limits independently? Or is this a hard limitation of the stock UART protocol/controller?

Curious if anyone's tried this on a TSDZ8 specifically, or if it's only possible with fully custom/flashed firmware. So any displays that can do this?

Thanks!

Hi,

Does the SW900 display (5PIN+2PIN SM connector, UART No.2 protocol) work with the Tongsheng TSDZ8 mid-drive motor controller? Or does the TSDZ8 require a different display protocol?

Thanks!