Stratified layers outside the model, late in the print
Never seen this before. At this point, its already printed the long part of the model, it starts printing these long layers.. Its not delaminating in the model, this is outside.
It is a New FEP,(2nd print, like not even 3000 layers to this point of failure) but this long part is parallel to the edge, just a bit inside the printable zone. not on the line, or over. Everything else in the print, other big and small parts came out fine. the raft, all supports were locked down to the plate like normal.
photon mono2, mix of sunlu standard and abs like.
Any ideas? is my bulb going?
u/Ok_Activity_3363 — 11 days ago