X Axis don't traveling to the end correctly
Hi! My Ender 3 V3 is not reaching the end of the X-axis correctly. I ran a bunch of tests on the microswitch and the switch is working.
I noticed an issue when I started a print and it started far more to the right instead of the center of the bed. So I started to test, and when I did the auto-leveling calibration, the X-axis was hitting the right side of the printer at the first line of the calibration.
Then I cleaned the belt, checked the tension, tested the microswitch click, and checked if the switch plug was loose.
And then I tested again and... it got worse. The X-axis was stopping halfway, not even close to where it should be.
Help please, I don't know what else could be.