u/Radojevic

Enphase just provided Enphase IQ Gateway software 8.3.5566 release notes:
https://enphase.com/installers/resources/documentation/communication?product_type=141&f%5B0%5D=document%3A217&f%5B1%5D=document%3A217%3F&media_id=35249&langcode=und

The Grid transition improvements feature is appreciated.
I did notice when the grid comes back up after an outage, the transition is faster, which keeps my networking equipment from power cycling.

Have you experienced something similar?

Enphase IQ Combiner 6C
Enphase IQ Battery 10C

My Enphase System Profile is set to Self-Consumption, and was providing my house power via Enphase IQ Battery 10C as normal during the timeframe mentioned below.

My electric utility company, PG&E, sends me the following during a utility power outage:
text message;
e-mail;
phone call.

I did not receive any power outage notifications from PG&E, however, ...

Displayed in Enphase Energy section:
11:32PM, Enphase Grid state changed to Off Grid;
4:35AM Enphase Grid state changed to On Grid.

System Events History displays nothing regarding going off grid, nor back on grid.

System Backup History displays the 5 hour, and 3 minute battery backup event.

The only thing I can think of is the grid voltage may have been out of acceptable Enphase System range, so Enphase treated it like a grid outage.

After 3 years of faithful service, Starlink Standard Actuated kit died:
router led off;
router pulls no power;
power cycling router 6 times to reset to factory settings does nothing.

Chatted with Grok.
Since I have Residential Max service, Starlink sends Starlink Standard 4X kit.
Ordered Starlink Standard 4/4X pipe adapter.

Removed old Starlink kit.
Installed replacement Starlink kit...

...except for the part where I:
climb into the attic with a flashlight, and a cable fishing pole;
walk on joists until the ceiling slopes too much;
lay down on joist platforms I installed last time I was up there;
grab the cable with the pole, and route it thru bedroom closet ceiling.

And then, belly crawl backwards until reaching the last joist platform, where I can hopefully transition from belly, to side, to sitting, to kneeling, to standing.
All without stabbing my head with what looks like spikes from hell.

And then stroll out. ;-)

Done.
It was more difficult than I remembered.

I'm never climbing in the attic again.

Might be a coincedence, but Enphase Enlighten App Release 26.5.1 arrived yesterday, May 20, 2026, and my Enphase Enlighten status stopped updating the same day around 10PM PT.

All lights are green on my Enphase IQ 6C Combiner.

Going to:
System ->
Gateway

Displays:
Connected to Ephase cloud
Status: Normal
Last reported: 21 May 2026, 03:35 pm (like a minute ago)
Firmware: D8.3.5557
Connection Type: Wi-Fi (Active)