u/Reaper-021

ELH Recon Lance ready for action. Thoughts or suggestions?

So a few days ago I ran into an issue where my A1 will only partially print a model, but keep going even to the point of saying the model is finished. This has happend to multiple models now and seems like the norm regardless of filament or model.

In the video it may be hard to see but I caught it just as it stopped feeding filament yet kept trying to print. Im not sure what is going on or even where to start troubleshooting. Any help or advice would be greatly appreciated.

For the last few days my A1 will start printing fine but will stop feeding filament yet keep trying to print, at times even saying complete even though it stopped feeding earlier on. The picture above is exactly that happening.

It also seems to have an issue unloading the filament after a failure. Its like the filament is stuck in the extruder.

Still new to working with the A1 but some advice or help would be greatly appreciated!

Finished the first of the Bounty Hunter set. Just need to varnish. Thoughts?

Currently working on the Bounty Hunter Mad Cat. Still have a lot of clean up especially on the launchers but getting there.

Without thinking I varnished a finished mini when the humidity was a bit too high, and it frosted. Is there any way to fix besides trying to strip it?