u/Renko17

Hi everyone,

I'm in final stages of planning my tb2 and struggling with a decision.

The 8x10 wall is specified as 2440 × 3048 mm, and here in Germany I can get plywood sheets in 1220 × 3000 mm. That would allow me to use two full sheets side by side (instead of 2 sheets and one horizontal addon) ending up with a wall that’s 48 mm shorter in height.

the hole pattern seems to have 10cm spacing at the top and bottom that this reduction should still work, but I want to double-check.

The frame and studs will be 5 × 15 cm.

Has anyone done this or see any issues (framing, hole alignment, etc.)?

And would you remove the 48 mm from one side or split it top/bottom?

reddit.com
u/Renko17 — 24 days ago