When I look in the review tab for alerts, and i click on a file, i get a pause every second or so with the playback. I have frigate for showing me alerts and use Unifi Protect for 24/7 recording. Since i currently have Reolink cameras, this setup works best for me since Protect won't use detection with my cameras.
My config file:
Had a print awhile back run out of filament so it sat in the idle state for hours. Then power outage while it was waiting for filament. Printer hasn't really been the same since. I'm swapping out nozzles and noticed the heat sink is very lose. Don't remember if that's normal or i should try tightened it up. For some reason I always have a problem getting the clip to seat properly and wondered if I loose heat sink would be part of the problem?
Anyone using unifi cameras in frigate? How do they work? Currently using protect as my 24/7 with frigate running detection with reolink cameras. Thinking of trading them to g5 turret pros.
Wondering if its feasible to use a power brick to charge thinkpad when an outlet isn't available? What kind of brick are you using?
I have an original Zimaboard that I was thinking of using as strictly as a backup to my to my main server. Just two HDDs to backup the data, no docker or anything like that. Run a backup to it once a week or so. Are there any pitfalls or things I should consider before doing this?
Lenovo T480s - Time Stamp
Asking $230/Best Offer, shipping included in CONT US. Please leave comment before sending chat.
Have a T480s I'm looking to move on from.
Specs
I swapped my .4 for a .25. When I pulled the .4 out it still had a cut filament in it. Was i suppose to purge the filament out of there first or will it just purge itself when I put it back in? Probably should have looked this up before switching
Looking for some 6TB ish HDDS.
Selling two Ryzen CPUs and some RAM TimeStamp
Ryzen 5 3600 w/ stock heatsink - $55
Ryzen 5 2400G (CPU only) - $30
2x16 DDR 4 3200 - $130
Canceled a print bc after it did a color swap, the new color didn't get laid down properly. Thinking back on it, I think the z axis was too high and it just pushed out filament.
So canceled print, cleaned plate and redid the print. This time it was trying to print but no filament was coming out so thought it was jammed. Pulled off the 4 in 1, headed thr hot end and used thr tool to push the jam through, got nothing.
Retracted all 3 filaments that were loaded and reloaded them. Now it looks like it doesnt want to push any filament into the 4 in 1, theyre just sitting there retracted and tried to print. Any suggestions
Have a combo set: $250 Sold u/50shadesOfEAids
AM4 3600 CPU in original box with CPU cooler $55
AM4 2400G CPU, just the CPU. $25
TimeStamp Willing to take more photos upon request.
I do have a AM4 RGB cooler to bundle with CPUs if interested. Willing to split shipping based on your preferred method. Can quote price before sale. Leave comment before sending Chat. I try to do first come first serve as much as possible but won't hold for long if others are willing to pay quickly.
Just as the title says. I'm looking to add some PTFE tubes from my Creality Space Pi x4 to and AD5X's IFS. Anyone do this? Do you just add couplers to the bottom of the AD5X's IFS and attach the tubes from there? Concerned about the couplers rubbing when the IFS cycles to load and unload.