Reposted!
Form 1 design
( Apologies I deleted other post to redo with a photo)
So I have a design i am working on and haven't filed a form 1 yet and I have zero materials for this but i see all over about freeze plugs , valve spring retainers and etc. I want to see if there are any other good options for making one without a lathe, I have drill presses and belt grinders for my knife making but I dont have a lathe or a mill . What im asking is it possible to make one without a lathe and have a reliable 9mm pcc can or no. I wont buy pre-made sauce cups and pre threaded tubes as I am not gonna take a chance on that. Everything in my design is made from all raw materials. Again I have zero materials other than a drawing. Than you in advance. Also the design has a giant end cap and I meant to make it smaller but this is a rough sketch