Buenas, tengo que viajar entre lujan de cuyo y Tunuyán un par de veces por temas de mecánico. Google me dice que hay bondi 821, pero online decia que solamente hay bondi de media distancia que se agarra casi en la ruta 40. Se paga con sube?
I got one of these printers off of Facebook Marketplace. Obviously used by a slob because it had filaments of all colors tangled around the belts and the bed assembly. I used to have a v2 so I was quite surprised about the differences, especially the speed. Thanks to the community here i found that the new slicer on the block is Orcaslicer, and after running a couple of calibration prints, i found out that not only there is something wrong with the printer, but also that orca has integrated calibration prints (Lol). I replaced the barrel with a bimetal, changed the bed surface, and printed a new part fan shroud and now im getting some good results.
Attached are the some of my calibration prints.
I do have some questions though.
The printer auto z-offset does not work reliably. It was giving me values between -1.24 - -1.37, and it wasn't printing well. I manually calibrated using the paper method, and ended with a value around -1.44, and im finally getting reliable first layers. Is there something im doing wrong with the auto z?
The printer also makes a lot of creaking noises. Sounds somewhat like someone with arthritis. During printing, and after a print has finished, it will make a creak sound, like a movement from thermal expansion. Typically its one loud noise, with a separation of at least 20-40 minutes. Sometimes ill hear it when its homing, in the y-axis. Is this normal? The v2 had springs on the bed, so im wondering if this is just the bed dealing with being fixed in place against the spacers.
Both are after, but before i manually calibrated the z offset.
