u/SeatOk1709

Samsung 28 cu ft french door, about 70% full. Kitchen was 76-78F during the test.

Results over 24 hours in UPS mode:

Total consumption including station idle: about 1.45 kWh

Compressor draw when running: 135-145W

Idle between cycles: 5-7W

Compressor duty cycle: roughly 35-40% (on about 15 min, off about 25 min)

Extrapolating: I'd estimate about 32-33 hours on a full charge at this load. That's under the 35 hour claim but their test conditions specify 25°C / 77°F and a 700L fridge. My kitchen was warmer and my fridge is bigger.

The idle draw is the real story here. 5-7W is genuinely low. My old EcoFlow was pulling 18-22W idle which is where most of the battery goes overnight.

I've been going back and forth on a desktop UV printer for months. My eufymake E1 just went on retail sale and there's some kind of promo happening. But I also saw xTool showed one at CES.

My use case is pretty simple, custom stuff for Etsy. Mugs, coasters, wood prints, nothing crazy. Don't need a huge print bed or anything industrial.

Is the eufymake E1 the right move right now or should I wait and see what else comes out this year? I keep going in circles on this.