u/Sensitive-Wind3158

Seems the only way I can get my Ender 5 pro to bypass this error is to cover the fan with the piece of paper as shown in the photo so it can get to temps when trying to print petg. No issues at all running pla with the slightly lower temps. It seems to be more so of an issue at the hot end rather then the bed.
So far I’ve pulled off the thermistor, cleaned up the little mess and added a little thermal compound. I’ve done pid tuning which had me change the numbers slightly but no change at all. Any advice would be greatly appreciated

Any ideas what the problem is here? Car has serious trouble doing anything to the right, can slide okay but is very slow transition back to the right. Played with alignment a lot but still no luck, front wheels aren’t rubbing for the record and spin rather freely