u/Sheffy__

• voxellab aquila (I have klipper set up on a raspberry pi 2b via fluidd)
• cura (I am using printsleo3d's aquila profile for all my settings)
• PLA amz3d
• nozzle=205 bed=50
• 40 m/s infill 20 m/s most other settings
• 6mm retraction distance and 45 m/s retraction speed

The print quality is the same as the last time/normal to me where it matches the gcode and I checked the gcode which I attached above and seeems fine in both cura and on the gcode preview on klipper. I also got back just under 4 hours into the print, the nozzle was about double the height that was printed from the model so I assume it got blocked (though I just had to push the filament through manually and it came undone so idek what happened there). Pretty sure there are retraction issues as a print I had done yesterday had a fair amount of stringing, poor top layer and holes in the side ( I will be drying my filament before my next print) Thank you in Advance for any help given!!