u/Shmoshmalley

▲ 14 r/joehill

Nos4a2 book vs mini series

So I finished the book a bit a week ago and genuinely enjoyed it, I thought it was a cool take on a vampiric story without being another Salem’s Lot or something. I know you run into the rush of every adaptation being different than the source material but you always have to hope it will be good. But my god it’s like the writers read the cliff notes and said we can do better and just whiffed it. It’s not a bad show and if I saw it firsthand., I probably would enjoy it just fine but all the changes just take me out. I get making changes if it’s something that is underwhelming or unimportant to the plot, I even get keeping Vic to two different ages vs 4 so you can use the same actress. I don’t mind small stuff being changed or small characters not being included like Manx’s second kid, but why do they need to shoehorn other characters and plot lines into it? Like why add the neighbor kid in the first season just to not have her in the second? Why add these other true creatives to the story just to rush the main plot? I have like 3-4 episodes left and it’s to the point we’re in just finishing the show to finish it to see the ending. Again not a bad show the acting is good with highly talented actors and the effects are impressive it’s just far less captivating than the book. I don’t know maybe it’s me.

reddit.com
u/Shmoshmalley — 8 days ago
▲ 22 r/turning

Newbie whistle question

Hey everyone, I’m very much an amateur turner I’ve only done a few small things just basically fiddling around to learn techniques. Anyways, I was watching some videos on the tube while my 3 year old watched the same show for the 15th time and she cozied up to me to watch too, so we watched a guy make a whistle and naturally she said she wanted one. So after a couple of attempts I had one that turned out pretty well it’s just not very whistley. If you blow I. The end there is a faint whistle sound otherwise it’s just like blowing through a tube. The whistle itself is about 4” long with a 3/8”x3” hole bored into it. The reed is flattened to slightly less than half the thickness. Any ideas what I might ne doing wrong? Hole too deep? Reed too big? Something else? Thanks in advance for any suggestions.

u/Shmoshmalley — 9 days ago
▲ 0 r/elegoo

Hey everyone quick question. My CC just had a firmware update For the canvas support and I updated to slicer as well. For whatever reason I cannot send the file to the printer. I can manually move the axis with the computer controller, but when I go to send to the printer I get an error that states that the printer is not connected. Any thoughts?

reddit.com
u/Shmoshmalley — 2 months ago