Am i the only one who cant decide the angle to cutting path when using zig-zag? I used to have this feature - but now it is gone. When i do the same cutting path over and over again it leaves the same uncut paths.
Am i the only one having noticed a remarkably better app performance today?
Hello I've had a Yuka 3000 for some months now..
It generally cuts allright - not as good as my previous Segway Navimow i108 - but allright..
Besides some smaller issues i have a cosistant issue with connection..
Everytime i open the app it uses A LOT of time to TRY and connect.. Many times it fails and i have to restart the app and retry.. Sometimes have to go physically to the mower to connect over bluetooth and sometimes even have to restart the mower..
I have tried blocking it from my wifi and only use 4g - same issue.. I have tried resetting it to facory settings and set everything up again..
But this problem persists.. Is it only me so i should go and have it repaired or i this a general problem for all of us?
Is the mammotion app just pure garbage or is there something wrong with my setup?
The app keeps sending me notifications about a job has started/paused/finished - even if the mower just stays in the dock?!
Keeps losing online connection - even with good wifi connection on the spot AND paid 4g.
Sometimes says the job is finished and goes to dock after 80% - no low battery?
Wtf? Its 2026.
Yuka 3000
14 days old
Good rtk placememt. 180 degree to the south clear view.