u/SpecialFram

Does anyone have any suggestions on how to get rid of these outer wall artifacts? Ive read that it might have something to do with natural frequency of a stepper motor or even not having interpolation on for my TMC2209 stepper drivers. I have it turned on with 16 microsteps. I recently switched to klipper on my printer and have only noticed these after switching. Any suggestions are welcome!

Flyingbear Ghost 4 with newly swapped out MKS Robin Nano V3.1 with klipper. Filament is Panchroma Matte PLA being printed at 190, inner wall speed is 60, outer wall speed is 50, movement speed of 200, acceleration at 1000.

Nevermimd the stringing issue in the photo, im more worried about the wavy looking lines.