u/Steampunk_balis

Does anyone have any ideas of what I can do to fix this toolpath origin offset issue?

I have a makera air.

The toolpaths are generated on fusion 360, or llightburn.

When I export the toolpath it is at 0x and 0y.

After importing the toolpath tends to be -40mm x and y outside of the bed space.

I usually need to start by fixing the offset and then refining it by 0.5-1mm increments to make sure its properly against anchor point one.

If I need to make slight adjustments and rerun a toolpath, it may not cut in the same place.