u/SteebyJeebs

Just curious if anyone has printed and used the bed adjust key on their Max4?

I didn’t have enough clearance on the old bed or new one. Has anyone else experienced this?

Hey Yall, what could possibly cause the fluctuation of the bed to vary so wildly? Its been printing for about 2 hours. I usually set my bed temp at least 30m before I begin a print.

Thanks in advance 😄

I'm having trouble finding info on what these mean/control. Clearly Acceleration is over in speed settings. But the rest are unfamiliar.

https://preview.redd.it/wbghuiwu6u0h1.png?width=975&format=png&auto=webp&s=f12c936ca4a174b1db2a0b3a34c98c701839193a

Hey yall, just wondering what to do to mitigate excessive power draws? I haven’t had issues yet, but I’ve got a q2, max4, two boxes, glowforge, gaming computer, and now my exhaust setup. I also sew in here sometimes and have a Roland piano. And it’s all in one room. I’d like to avoid tripping the breaker.

Any suggestions?

Thanks in advance 🤞🏽

I did a chamber quality check and was a bit surprised, so I’m returning and getting a new one. Too many issues to fix and I don’t need anymore obstacles. But I love my Q2, let’s hope by the time I get the next one, some of the kinks are ironed out 😁