I am definitely interested in some of those agencies but it seems like a lonely life to literally not be able to talk about what you do. Are you allowed to say anything? I guess this thread might be for free-lipped retirees only lmao
Hi! I’m building a self balancing robot with a head on a servo gimble. I have an esp32 s3 matrix, pi zero 2 w, mg90s servos, and 12v 300rpm n20 encoder motors. I’ll likely have an arducam, 1.3” oled, a speaker, and time of flight sensor.
Right now I’m stumped on two things: motor/servo driver board and power/battery for the system. Any assistance would be hugely appreciated
Hi folks!
My goggles take 4 total antennas. Usually it seems 2 is enough! Is it safe to only screw in anetennas on one side, should I remove the module on the other side? Only ever run 4 antennas? Or another mystery option?
Since the gimbles have a square range of motion I’m curious if they are normalized or programmed naively. Does full stick deflection to a corner apply. higher rotational acceleration than full stick deflection to the edge?
I know this is encoded differently between xbox and playstation controllers, so it might be radio specific. I have a radiomaster pocket elrs.
Hi! I made a custom splash image for my boot screen. But i’d love to also hide the version number and the tip on opening the stick options stuff. Are there CLI commands to do that? Cheers all!
Latency is too much to fly? Genuinely you’re telling me
Hiya! Whenever i land my new air75 it does this crazy hopping thing. I can disarm to make it stay still but i feel like this is not normal
Edit: solved. This is caused by air mode. I opened betaflight, disabled permanent airmode, and bound it to one of my radio’s shoulder buttons. Now i can toggle it off to yawspin on the ground