u/StupidThangs

Will finish dropping it in tomorrow then we got fuel lines, wiring harness, and other miscellaneous things to modify.

So far we've wirebrushed the majority of the engine clean, cracked open the powersteering pump to make sure it was good, welded a new bung into the oilpan because it was stripped out past a 17 course thread, threw on the other sc400 parts, replaced the front and rear main seals, repacked the pulley bearings, installed the 7m oil pressure sensor, replaced the timing belt and waterpump, figured out the AC top plates are interchangeable, replaced the studs on the fan pulley with shorter bolts, replaced the distributor caps and rotors (one was installed wrong), installed new sparkplugs and wires, did the oil change, installed non broken plastics, reinstalled the serpentine, and fixed chewed vacuum lines. Next thing on the list is to clean up some wiring, flush the blocks coolant channels, and figure out the temp sensor thing I read on one of the forums.

Almost time to pull the 7m