Well pump replacement
Didnt have water and discovered there was no pressure coming from this. Figured out I was getting power to the pressure switch but it wasn’t running. Replaced the pressure switch and it started running but no pressure was built and it didn’t prime(after letting the motor run for 24 hours) so killed the power to the water heater and the well pump. Whatever hobgoblin installed this appears to have possibly directly glued ts to the well pump so I might have to cut pipe. I’m replacing the whole pump so my question is cutting the pipe a good place start? Do I need to do anything specific before I just start using my Ironworker brain to fuck around till I find shit that works? I’d prefer at least a rough guide to at least point me in the right direction so I don’t blow a bunch of money. Thanks in advance.