u/Tamelon

Well short said, sometimes those stucture basicly vanish flow wise.

the dams are like they stop to exist, water on the inside only rises to the bottom on the dam and flows right through it.

fill valves behave like they are either open or closed. if i set them to 0.05m they open fully and the reservior behind them doesnt fill up.

throttling valves behave the same, they are either fully closed or fully open.

when i rebuid them they are fine again, or not. basicly a 50/50 chance if they work or not. Its confusing to see your main water store empty 3 days before a drought. rebuilding gets complicated when they sit at the bottom of my main water reserve which is 10 blocks tall...

anyone had such a problem and can come up with a solution? i use a few QOL mods like statistics and such. the only mod which changes gameplay is the one that allows multiple connections to ziplines. saves some space since you can allways build multiple stations next to each other.

thanks for your time.

hi,

i have a new notebook, on my old notebook wireguard is installed with a tunnel to a fritzbox. i use it to rdp to a terminalserver. everything is fine there. (w10)

on my new notebook i have w11, i installed wireguard and imported the same config file for the tunnel (i compared everything in the config editor) the tunnel opens correctly and i can rdp to the server as usual. but after a few minutes the rpd connection closes and i cant reopen it. wireguard is still active and connected. but i have to close the tunnel and reopen it to reconnect to rdp. after another few minutes same, rdp closes and i need to reopen the tunnel.

on my old notebook everything is fine. im in the same wlan using the same ISP so i think its not related to that.

anyone an idea?

i have 2 forges atm both requiring copper and iron. sometimes a train unloads everything in the 1. forge and then there is no need to drive to the second forge just to do nothing. is it possible to setup a line to skip stations if trains are empty? or is there another solution?

Thanks

so my housing area constantly complains about not having enought water and electricity. i have build multiple transformers and the water equivalent. still im not fulfilling the demands.

i have plenty of water available, the building is connected to a full large fluid storage full of water with 2 t4 pipes. still its not sufficient.

i have a surplus of at least 300 MW of electricity and 3 transformers still its not enough.

if its important, i have almost 12000 people living there.

currently trying to fulfill all their needs but i cant get water and electricity working...

thanks for your time

Hi there,

a customer has switched from IMAP to Exchange Online. All went good so far. one issue remains:

the customer is using an info@company mailbox which was converted to a full mailbox in exchange online.

in the IMAP Environment every Outlook was configured with a different Sender Name in the info@company mailbox.

So

PC 1 had "John Doe at Company" as Sender Name

PC 2 had "Jane Doe at Company" as Sender Name

both sending with info@company email adress.

now it seems i cant configure the Sender name in exchange online / Outlook, so all mails now go out with Info as sender name which results in many mails end up in a spam folder.

Is there any way to include some sender information in the name? same problem exists in other mailboxes used by multiple persons / PCs but info is the main mailbox and i have to find any solution...

Thanks for your time.