What does the corridor look like above the level 35.5 (maby 38 or stn’) hoe would someone get to steam seperstors rooms?

u/TheChernobylArchivis — 1 month ago

What are these and what do they show in the Chernobyl 2nd phase?

I think these are electrical, but I’m not Shure.

u/TheChernobylArchivis — 2 months ago
▲ 170 r/chernobyl

RBMK layout map

This is a layout of the РБМК-1000 reactor lid (NOT ELENA)the one basically shows where the grid maps the layout of the channel caps in reactor hall №3/4 of Chernoby and Kursk, or №1/2 in Smolensk.

u/TheChernobylArchivis — 2 months ago

Looking for someone to yap to

I’m 19

Likes : Roblox,Minecraft,rivals,Chernobyl

Hobbies : making Roblox games about Chernobyl, making F3X builds about Chernobyl

I don’t care if you spam me, yap at me, or just chat! I want to know you all that see this post!

reddit.com
u/TheChernobylArchivis — 2 months ago

PRIZMA/SKALA calling device codes.

These are the codes of the Skała request system, wich managed the whole reactor (aka SIUZ,SIUT,SIUR)

u/TheChernobylArchivis — 2 months ago

12.5.2000 unit 3 accedent,

 As I quote “On December 6, 2000, Chernobyl Unit 3 experienced a technical malfunction when a coolant water leak developed within the plumbing system of its Main Circulation Pump loop. This component was crucial for pumping water into the RBMK-1000 reactor core to prevent it from overheating Because a loss of coolant can cause an RBMK reactor's power to spike dangerously due to its positive void coefficient, operators took zero chances. They immediately pressed the AZ-5 button.  Then the s Shift supervisor Viktor Kuchinskiy, wich made the  manual command  to trigger the "Fast Emergency Protection" system, which rapidly dropped all remaining boron control rods into the reactor core the power went from 200 MwT down to 0 MwT and the boron rods went down ro absorb neutrons and halt the nuclear chain reaction completely.  the room in question thst this happened was 404/1 This room houses the Group Distribution Headers (GDH / РГК) on the right side of the Unit 3 reactor. The leak occurred when a crack or structural failure developed in the piping or welds near these distribution headers, which are responsible for funneling high-pressure water coolant directly into the individual fuel channels of the reactor core. Because the leak occurred in an unserved (unmanned and highly isolated) area of the primary cooling loop, technical regulations gave operators no choice but to trigger an immediate emergency SCRAM to safely depressurize the system
reddit.com
u/TheChernobylArchivis — 2 months ago