u/TonyK61

Not happy with the feed path on the Troodon 2.0 Pro. I've searched but have not found any better path.

With my Ender 5 Pro I have a loosely fitted reverse bowden tube which works well. The E5Pro is now a direct drive printer. The Flsun v400 had a pretty good arrangement as well.

Has anyone changed the filament path or reduced the bowden tube? Why? Because mine keeps getting pulled in tight to the extruder assembly which makes it harder for me to load or unload filament.

If I could move the filament holder to the top of the frame I could go naked (aka no bowden tube). Not going to use the run out sensor. It is disabled at this time with a piece of filament.

Internet searches haven't revealed anything to me yet but I keep trying.

Thank you,

Getting this warning:

"MCU 'mcu' has deprecated code (it is missing feature 'STEPPER_STEP_BOTH_EDGE'). Recompiling and flashing is recommended (MCU version 'v0.11.0-241-gffb5105b', host version 'v0.13.0-649-g4767a8ed9')."

I can do a make menuconfig. Just need to know the options to select before saving and then I can do a make and the flash the new MCU firmware to the printer.

I've done this before on my Ender 5 Pro when it was moved to Klipper.

Any help is appreciated.

Thank you,

UPDATE: Issue resolved. See comment below.

Have done my best to get the gantry level to within 1mm by using pill bottles from the pharmacy of the same size and height (sort of like using soda cans) but I'm still having this error.

Have searched with Google and am not having any luck finding a resolution.

This is a stock Troodon 2.0 Pro just assembled and going through the first setup steps.

Thoughts about moving past it?

Thank you,