I just bought a bear legit maxx bow. I like the bow, but I would like to align the cams. They are slightly off center. Does anyone have a suggestion for an economical bow press, or should I just take it to an archery store and let them do it? I know how to align the cams, but most of the bow presses that I've seen cost more than the bow. All information and suggestions are greatly appreciated.
Thanks,
Tuv
I created a multilevel scene in Foundry VTT 14 for D&D 5e. I created a generic player character actor and added it to the scene. That's all good. I added an ape and a couple of wile boars from the compendium. Still all good. I then decided to create another actor as an NPC. It is designated as an NPC. I changed the image for the NPC and dragged it to the scene. All actors are on level 1 and I was on level one when I dragged the NPC to the scene just as I had for the player actor and the ape and the 2 boars. When I drag the NPC to the scene, it just disappears. I used the tab key to cycle through the players and other animals but it did not highlight. I then created another actor as an NPC and did not change anything. I dragged and dropped it onto the scene. I did not change the level. I made sure that everything was on level one and I placed the NPC on level 1. The other 4 actors in the scene work perfectly fine. I even changed the token image for the player actor and added it to the scene again and it worked perfectly fine.
To reproduce my issue. Create a multilevel scene. Go to the actors tab. Create a new actor and designate it as an NPC. Attempt to drag the NPC to the current level.
If anyone has any insight to this issue, please let me know. As always all and any help is greatly appreciated.
Thank you,
Tuvarin
I created a multilevel scene. The scene has a main level 1, a roof level 2 with two tiles on it and a lower level below level 1. On level one, I added an NPC ape to test that the roofs disappear when the building is entered. That works. However, the fog of war didn't work for the ape. So, I created a player actor on level one and the fog of war works for the actor. However, when I select the ape, that can see everything without the fog of war, it can see the test actor. When I select the actor, the fog of war works fine, but it cannot see the ape. I have verified several times that they are on the same level and that they both have the same elevation. Both the ape and the player actor have a vision range of 60 feet. Both the ape and the actor are outside any building and are within 20 feet of each other and the player actor still cannot see the ape.
Does anyone have any advise on this situation? Any help would be greatly appreciated.
Thank you,
Tuvarin