Maxing out the marauder issues with limited pins (cydc5,nrf,gps,esp32s3,flux capacitor, LORA stand alone with fan (several obstacles need help with por favor)
Hello, I’m new to this but I’m about 4 months into this tension headache from learning. I have a flipper zero I had previously and professionally i build motorcycles and fix /modify clusters and do odometer corrections so i can microsolder and use a multimeter and I have digital microscopes as well as a 55” Intouch pc running kali to check the rssi before and after.
My goals are to try and build the beefiest yet usable device I want the limitations to be only because it’s not a computer so basically best it can be.
I planned on running multiple nrf24 I have 4 available
Also hooked up to rabbit labs flux capacitor (c1101 boosted)
Running ebyte 900m30s 915mhz
Nm Cyd c5 resistive 2.8” for the new WiFi capability
I also planned on running a esp32s3 lonely binary
I ALSO have a cyd S3 2.8 capacitive touch at disposal
GPS is sequre m18-10 and I converted it to external antenna
I have 4000mah 3.7 lipo
5v hydraulic bearing brushless fan turbo shaped
I have a bunch of ipex to sma adapters
3 antennas for 915mhz
A small tx433-js-5 antenna that came with flux capacitor
Also have the voltage step up module
And a few battery charge modules
My questions:
The flux capacitor has a ipex plug on it what is that for? It already has an antenna mount. Could that be utilized to benefit its strength?
The s3 lonely binary has external ipex plug. Do I still need to mess with the o ohm resistor?
How many nrf24 are beneficial? (I guessed 2)
How in the world do I convert the c5 to external antenna there’s zero online for which traces to cut I have the the shield removed to see better
I keep having issues with Bruce not finding nrf24 when testing them
The gps, i have no interest in war driving. Is that practically all it’s good for in my setup?
Antennas which ones need to be separated, and can i have them all vertical and side by side?
Is it possible to run both Cyd and the esp lonely binary together. I was thinking about having screen 2 continuously stream the signal strength of each and the current gps location
Is there anything special for mounting the Lora module? It’s a big rectangle with solder pads below it.
Can anything be integrated? Like connecting all together as one unit. I do have perforated circuit boards of many Shapes I can use and I have a big box of circuit boards from kids toys, to flat screens, cable boxes, anything and everything common in a household so if I need anything I probably have it.
Also is there anything I’m overlooking or any info you think I should know
Thank you a ton! Here’s a photo of the traces on c5 and photo of Lora
The red dots on drawing are areas I took the surface off of gently to use multimeter and all points had continuity with ground so I’m assuming it’s layered.