u/Unlucky_Bed_4239

Laid my '05 xb12scg on a rural az mountain road when a truck pulling a trailer was coming at me 3/4's in my lane on a blind curve. Needless to say I finally have a chance to rebuild her.

When I laid it down, it snapped my shift linkage etc and stripped the bolt under where the clutch cable enters the primary. In a quick fix to get it home, I rigged up a couple wrenches for my linkage and put a dab of jb welded to hold this bolt in question in. It worked and the jb weld isn't in the threads.

Obviously the bolt threads being stripped is an issue tho.

My question is can I tap the hole and step up a bolt size? Or any other options you all might have I'd appreciate greatly

" edit - I mentioned below but it's been heli'd previously by the former owner or when I sent the case in to have the clutch ramp fixed