Login

u/Valuable_Context_187

Image 1 — 2nd QC - Feedback Needed
Image 2 — 2nd QC - Feedback Needed
Image 3 — 2nd QC - Feedback Needed
Image 4 — 2nd QC - Feedback Needed
Image 5 — 2nd QC - Feedback Needed
Image 6 — 2nd QC - Feedback Needed
Image 7 — 2nd QC - Feedback Needed
▲ 1 r/RepTimeQC

2nd QC - Feedback Needed

Hello All,

2nd post after RL the first one from Andrew. It doesn’t seem that this second one has addressed the original reason for RL, and in fact may be inferior. This is new territory for me. Any help would be appreciated!

⁠Dealer name: Andrew (TrustyTime)

⁠Factory name: VSF

⁠Model name (& version number): ROLSUB0367 - Submariner 114060LN No Date 904

⁠Price Paid: $448 with shipping

  1. ⁠Index alignment - Nothing obvious, looks clear and well aligned
  2. ⁠Date Wheel alignment - N/A
  3. ⁠Bezel - 3 and 9 look slightly rotated CCW...within acceptable tolerance?...at least I think so, but would appreciate feedback.
  4. ⁠Solid End Links (SEL) - possible gap on the top left?
  5. ⁠Hand alignment - No issues founds
  6. ⁠Dial Printing - I don’t see any improvement with the"Swiss Made" being too close to the 6 index? This was the reason I RL the first one. RL again?
  7. ⁠Timegrapher numbers - concerned that the -7 seconds is on the higher end but more worried that the amplitude is on the low side. Thoughts?
  8. ⁠Anything else you see - Will ask for an additional picture to confirm alignment of the 12 bezel and dial. The rehaut also looks misaligned
u/Valuable_Context_187 — 14 hours ago
▲ 6 r/RepTimeQC

Hello all! First QC, any help would be appreciated!

Hello All,

Long time follower, first time posting. This is my first QC, any help would be appreciated!

⁠Dealer name: Andrew (TrustyTime)

⁠Factory name: VSF

⁠Model name (& version number): ROLSUB0367 - Submariner 114060LN No Date 904

⁠Price Paid: $448 with shipping

  1. Index alignment - Nothing obvious, looks clear and well aligned
  2. Date Wheel alignment - N/A
  3. Bezel - 3 and 9 look slightly rotated CCW...within acceptable tolerance?...at least I think so, but would appreciate feedback.
  4. Solid End Links (SEL) - No obvious gaps present
  5. Hand alignment - No issues founds
  6. Dial Printing - Nothing obvious, however does the "Swiss Made" look too close to the 6 index? Also looks like some dust inside...asking the TD to confirm....if confirmed, enough to RL?
  7. Timegrapher numbers - All acceptable
  8. Anything else you see - Nothing obvious, I did ask the TD to send photos of the rehaut.
u/Valuable_Context_187 — 11 days ago