I took my bass guitar to a luthier because the neck broke. He did a simple glue repair and it's fine to play now, but my question is, it seems the truss rod was covered with glue, and now it doesn't turn anymore. Could this cause any problems eventually? I apologize if this is a silly question; it's my first bass and I've never taken it to a luthier before
I took my bass guitar to a luthier because the neck broke. He did a simple glue repair and it's fine to play now, but my question is, it seems the truss rod was covered with glue, and now it doesn't turn anymore. Could this cause any problems eventually? I apologize if this is a silly question; it's my first bass and I've never taken it to a luthier before.
Fala galera, esse é meu bass, tagima tw65, to pra pegar um jazz bass mas queria fazer algum upgrade no meu atual, acham que compensa? Alguma ideia de por onde começar?
Oque acham dos modelos Jazu da Seizi? Alguém tem alguma opinião? To pensando em comprar pra ser meu primeiro jazz bass, aliás achei bem diferenciada essa pintura do headstock
Bom galera tava com curiosidade sobre essa parada de simulação de caixa pq onde toco usamos tudo em linha, peguei uma blackbox da mvave por 150 reais só pra testar e ver como é, achei meio estranho o timbre das simulações que baixei (não usei nenhuma de fábrica) todas pareciam graves demais, isso me deixou com pé atrás de investir num pedal mais caro no futuro, pq pra mim seria uma das principais vantagens, enfim, oque acham? Será q é o pedal baratinho ou eu não curti mesmo
I recently bought an Mvave Blackbox to test some cabinet simulators. I paid very little for the pedal, and it was cheaper than most other entry-level pedals that have cabinet sims. I was a bit disappointed with the simulators I downloaded, which had good reviews. They all sounded abnormally bassy and had a slight delay that didn't bother me too much. This made me hesitant to invest in more expensive, high-end pedals to use as simulators. What do you think? Is it the cheap pedal, or did I just not like the "simulated" tone?
I have a preamp that I love for its distortion tone, however, I want to use an amp simulator for the PAs. I don't have a parallel signal with the cab-sim disconnected. Is there any problem using the cab-sim on the stage cabinet?
the stage cabinet is a hartke lh1000, i was wondering using his send output connected to my cabsim to pas, but dont know if will work