u/Visible-Animator3654

I’m going to do an overhaul on my kobra S1, I’m looking at trying to find the lightest no magnet print head shroud, maybe a storage consumer riser, and a cooling duct upgrade. Any suggestions?

Every single aftermarket hotend I’ve owned has clogged within the first month of ownership, and both have killed the printhead board, any solid alternatives?

My kobra s1 bed got soaked in white lithium grease and shorted out, although before that I had ordered a funssor bed carriage by itself, what’s the cheapest bed heating kit from AliExpress that can go on top of the carriage and where are the install procedures?

I have an 03 beetle with a cylinder 1 misfire ( it keeps bouncing around) with new with new iridium plug and an SAI air leak that’s been duct taped together with a little bit of air escaping on startup, this has caused the car to violently stall and then jolt mostly going uphill or on cold start and high speed. Any other hints to what it could be?