I recently picked up the 60v 16” chainsaw and if I don’t have it laying on the right side it leaks bar oil all over. I add an o ring to the fill cap and left it for a while and it still leaked. Anyone have a fix for this? It’s a great saw and it’s super useful but the leaking is super annoying.
After many design changes I’m going to be getting help welding up custom verticals and crossbars to bolt my ARB RTT up to the trailer I’m building. Would 1/8” wall 1.5” square be sufficient or would something like 1/8” wall 1”x2” tube be better? Tent weighs about 150lbs and total weight will be under 500lbs with 2 adults. Crossbars will be pretty low at about 36” height off the ground so there shouldn’t be massive wind drag since it’ll be well below the roof line of the tow vehicle.
Took delivery and assembled a 4x6 Carry-On trailer Friday. Today when I got it hooked up I was only getting the driver side front running light. I check the 4-pin connector at the vehicle side with a tester and everything is working just fine. I redid the ground on both the vehicle and trailer side and they’re both getting very good metal to metal contact. I can’t figure out why only the 1 light is working. Iv tried everything I can think of and spoke to an 30+ year electrical engineer and we’re both stumped. Any ideas?