u/Waste_Database7075 — reddlx

Boost Leak test

When is the BOV suppose to open when your charging through the turbo inlet. Intake is seeing pressure sending it to the top of the BOV.

Just double checking myself it should open when I reach the target boost I’m making correct? On a static pressure test?

Sr20det s13 blacktop, Greddy Type S venting to atmosphere. Stock ecu targeting 7-10 psi but I’m only seeing 2-5 on both gauges driving, and the bov opens at 2.5 psi during static testing.

reddit.com

u/Waste_Database7075 — 3 days ago

▲ 1 r/240sx

Turbo play t25

There’s no in and out play boys but a lot of side to side, and up and down. Barely touches sidewall but I’m sure under load and etc it might.
Garret t25 stock s13 sr20det
Rebuild is due probably?looking for a second opinion as It’s a journal bearing turbo, haven’t had one yet.

u/Waste_Database7075 — 5 days ago

▲ 5 r/240sx

Shaft Play (😏) sr20det rwd

Anyone able to tell if this is too much shaft play on a sr20det rwd manual trans? I have a whirring that goes away with clutch pressed in.

Already planned on doing pilot bushing, and TOB, rear main seal. Should I take a look at replacing the bearings in the mid plate?

And I’m ready for the Reddit jokes but I’d really appreciate actual info! If enough think it’s bad I’ll have it actually measured.

u/Waste_Database7075 — 19 days ago