u/Zasimp09

Hello,

I have a pre facelift i30n and my valve spring has gone so in typical car idiot fashion that means the logical option is to replace the system😂

Been looking at RPM Performance as they seem to be quite prominent for exhaust parts for hyundai and are at a reasonable price. Also got my gpf delete from them and was good quality at a solid price no complaints thus far.

Curious if anybody here has experience with the axle back on any model from RPM and how they perform?

Also wanting to go with the single silencer, actuator, and double wall burned tips. Do you find the lack of full back box makes it too loud?

And do you know if RPM will accommodate the burnt tips as theyre not a direct option however 5" tips do not fit the pfl so 4.5" double wall would be needed instead

Thanks

Any feedback is welcome

Curious on if anybody has made up their own or found a good manufacturer of an extra air duct to guide up into the bay from the main grille, or an extra duct from the lower side grille up to the air filter on the pfl.

I believe rpm do a main grille duct for the facelifts however it's the only one I've seen.

Needing to increase my engine bay cooling and trying to reduce heat soak. Potentially increasing air flow to the filter is my best thought at the moment. Otherwise, bonnet vents it is😂