I just got my canvas system for the CC and every time I load a filament it loads the filament but flashed red on the spool i just loaded. I can't print anything because of it and it doesn't give me an error code or anything.
UPDATE: I found that I needed to reseat the sensor cable. I'm assuming it was a loose connection and that caused the sensor not to sense that the filament has been extruded.
I just got my canvas system for the CC and every time I load a filament it loads the filament but flashed red on the spool i just loaded. I can't print anything because of it and it doesn't give me an error code or anything.
I downloaded gemma4:e4b GGUF file form unsloth on hugging face and when i try to upload to open webui it doesnt work. I go to admin then models then experimental and tried to add form local file. It would then disconnect, reconnect, quickly go to 100% upload progress, disconnect and reconnect me again, and then sit there with a spinning wheel without actually uploading.
I set up web search for my models using searxng but after i updated to the newest version of open webui now anytime i use the web search it finds sources and immediately says “no sources found”. i checked the settings.yml for json files support and i did enable it. i also increased the context window and it didn’t do anything either. i haven’t seen any other solutions. does anyone have a fix?
UPDATE: I turned on "bypass web loader" and for some reason that fixed it. I'm not sure if the default settings for the web loader engine is just bad or something but it aparently was why it wasnt working.
I updated to the new version of open webui(v0.9.5 and tried the cuda version) and now when trying to run any model it uses the cpu and not the gpu even tho i used —gpus all when updating. i’m using debian 12 and docker