DIY CLAW MACHINE
I’m trying to do a claw machine from a kit I bought from AliExpress but there’s no such thing as instruction manual there lol.
Curious on a part I’m stumped on.
Look at the top tab, the single one near the top edge. Right above it there’s a tiny molded symbol — a little circle with three lines under it (⏚). That one is Earth. So I’m sure the green/yellow wire goes there. That one I’m confident about, because it’s clearly marked and isolated at the top.
But here’s the honest problem with the rest:
this box has two separate things sharing the back — the IEC inlet (the three flat tabs grouped at the bottom) and the fuse + switch tabs (the screw tabs up top). Live has to thread inlet → fuse → switch → out to your wire, and Neutral threads inlet → out.
I don’t have a multimeter But im trying to figure out how to pplug
The LIVE AND neutral or where would it be on this
This is a switch box
I’m left with red and black wires now