u/alcaron

So, just got my E1 and I'm starting to think it is not working properly...I walked through all of the calibration obviously, but I have a problem where the camera alignment, even in the dead center of the mat, is about 3mm off to the left.

I thought eh cameras are cameras...lets try zero point.

Except here is the problem. I do the calibration, measure the mark on the mat... -7mm on X -8mm on Y...max you can enter is -5...

It's going to be an expensive paperweight if I can never get anything to align until I spend three prints lining stuff up...

Am I doing something wrong or is it time for an exchange?