Hey everyone,
Anyone experience the print actually lifting the corners of the plate off the magnetic hot bed, but the print still adhered to the plate itself?
It obviously warps the print and I’ve printed these parts twice and have it happen both times.
I’ve only ever had it happen on this print, and a couple different plates of this print where the objects were running corner to corner.
Thanks,
Craig
A 10hr print I was doing ran out of black filament at the 92% complete mark :/
The print paused, and when I replaced the black spool and resumed, the KX gives me filament tanglement errors. I stripped it down as much as I was comfortable, and noticed the nozzle was clogged with the last piece of black filament.
I followed Anycubics advice on how to clean a clog and I got as much out as I can and made sure that new filament can fit into the nozzle, with the hope that the new roll would just push the remaining gunk out as part of the warmup process.
Alas, still getting the error after I put the nozzle back home.
Any thoughts about how to clean it out or am I missing something else?
I’m going twitchy not having the printer running…
Thanks,
Craig