u/digitalhick

I have run the bed levelling procedure repeatedly and everything appears correct when done. However, when I send a print the nozzle is about 3mm above the print bed. I am using the paper technique and auto-levelling and nothing helps. Does anyone know what is happening?

### UPDATE ###

I restarted the printer and re-levelled the bed. This time I checked the z-offset again after the automatic levelling had finished and made a minor adjustment, then hit the disk icon to save the settings. I then started my print from a USB stick rather then over WiFi from Orca and the print is working perfectly. Not sure if it was the levelling process or the use of the USB rather than WiFi but I am printing for now.

I have purchased several books on Roll20 but have never had any success in accessing them through Demiplane. If I want to just read any of the books, am I able to do so on Demiplane? Also, what books are availble on Demiplane from Roll20 (I am aware not all of them are).

Thanks.

https://preview.redd.it/fudrjbi7mmzg1.png?width=1122&format=png&auto=webp&s=c81b951468b2494674996ac1f03babf21ec5a304

In a hidden room in the basement of a church our band of adventurers stumbles into a demonic ritual led by a hideous banshee. She is displeased about the unwelcome interruption!