u/fingerboardio

Hey guys, I made this little stand to display my setups. Each block holds one setup and you can stack as many as you need.

It’s light but sturdy, prints in about an hour, and doesn’t need any supports.

The files are free on MakerWorld:
https://makerworld.com/en/models/3401297-fingerboard-stack-rack-modular-display-stand#profileId-3872623

I made a 3D-printed riser for my BRR Marble Box Low so it lines up with the stairset and can be used as a ledge.

If you happen to have both ramps (and a 3D printer), the model is free to print:

https://makerworld.com/en/models/3262845-riser-for-blackriver-marble-box-low

Made a printable version of the Blackriver Ironrail Round Low and figured I’d share it here.

It’s 300 × 60 × 40 mm, prints in about 1 hour, uses ~25 g of filament, and needs no supports.

https://makerworld.com/en/models/3237325-fingerboard-round-low-rail