u/khariV

I recently updated to a EA version of Network (10.6.94). One of my U7 Pro Outdoor APs dropped off of the network. I did some diagnosing and ended up rolling back the update. The AP showed up again.

Then, in the past day, my switches updated to 7.5.10. My AP disappeared once again. This time switching ports and dropping / readopting didn’t help. The only thing that I was able to do to get it to connect is to switch the port to turn off auto speed negotiation and set it to 1g. If I set it back to 2.5 or auto, the AP disappears. 1G - it shows back up.

It has been working just fine for about a year now, so I can’t imagine the cable has suddenly gone bad. I also don’t really want to go out to take down the AP to try shorter cables.

Does anyone have any idea what I can try to get it back to 2.5? I have not yet opened a support ticket, as I figured I’d check here to see if anyone has seen similar behavior.

For reference, my other U7 Pro Outdoor APs work just fine. They are all connected to the same XG 10 PoE.

I know this may be blasphemous, but I am looking for battery mounts for my One+ batteries to attach to my Packout wall mounts. I've looked on Etsy and haven't found anything from any of the Packout or 3d printed stuff vendors.

Does anyone have a link for this sort of bracket? I'd really like to avoid having to mount Ryobi branded wall plates to fit their own battery mounts.

Thanks

I just replaced my UCG Fiber with a UDM Beast (don't ask). I managed to restore the network and all of my devices appeared correctly without needing to re-adopt, so that part worked flawlessly.

The only issue is that my ENVR and UNAS Pro 8 are now showing up as separate sites in the Unifi Site Manager. Prior to the migration, all 3 (Network running on UCG Fiber, Protect running on EVNR, and Drive running on UNAS) were all under the same site. The help documentation says that you just have to click on the ENVR/UNAS and select Merge from the site manager, but there is no merge.

I have verified that there is only a single instance of Protect running.

How do I merge my devices back into a single site? I really don't want to factory reset and re-adopt them as there are a LOT of drives to reformat and cameras to re-adopt etc.

Is there some trick to getting Merge to show up in the Site Manager? Is it a matter of waiting for some cycle? I have tried restarting, but that does not seem to have any effect.

thanks

As the title says, I’m looking for a Unifi USW Pro Aggregation switch to add to my rack to play with 25g.

PPG&S of course.

Let me know if anyone is looking to rehome one.

Thanks!