u/lantruong

Almost done! I just need to trim and tie off the strings at the bottom.

It’s made out of fuse beads.

The toner reactive foil isn’t sticking to some areas. Anyone have tips for getting a nice, clean, and complete application? I’ve tried using a higher heat setting on my laminator, but I don’t think it’s helping much.

This is taking me an embarrassing amount of time to finish. The pieces are cut out of 3mm basswood. After spray painting everything, I lost one of the tiny green pieces and it sat unfinished for weeks on my living room floor. I finally found the missing piece yesterday in my box of spray paints — which I had searched multiple times before — and was ready to glue everything down and hang it up, but then I realized the back of the piece needs a couple coats of black spray paint before any gluing can take place. I hope to finish this and have it hanging up in my place soon!

Available for purchase for $2 each, shipping included. Send me a message if you’d like to buy one!

I followed the instructions when assembling it, but it leans noticeably to one side. My floor is level, so that can't be the problem. Anyone else run into this issue, or anyone have any tips on how to fix the lean?

I ran out of white beads and just ordered some more.

I started a new beaded wall hanging (the white, green, blue, and black piece under the cat). I hope to finish it in the next week or so!

Made this mini print! Available for purchase for $2, shipping included.