u/markh21518

​

I accidentally killed my SD card which had my Klipper installed on it. I'm running a BTT Manta m5p with a CB1. I have been able to flash both the Manta and my secondary creality 2.2 board with the CB1 and they both communicated. If I use the premade image from BTT, or install kiauh and then put on the pieces of Klipper it's the same. I can see the boards when I do an LS /dev/serial/by-id. But Klipper will not talk with the boards, either one or both. I'm just baffled why? Thanks for any help you can give. Everything was communicating before I destroyed the SD card.

Solved, I had another MCU line in the printer.cfg. once I removed that both MCU's connected.

Thanks for the help everyone.