Hi everyone. I have this kayak and some of the sliders got oxidised. I have done vinegar and warm water, removed a lot of it but they aren't moving. Underneath they look fine to what I can look, so the problem seems to focus on the inside and teeth. Any other home remedies to try or what type of product to buy? I am going to Decathlon later.
Hello,
Recently bought a GL.iNet GL-A1300 Slate Plus and been using with Tailscale to connect to my home network Exit Node. The Slate Plus is connect via WiFi to the main router (4G).
Where it has been working great, recently an update on a laptop I use for work, it seem to have leaked the main router IP/Location, and where I don't have problems to work remotely, the goal would be, to always have the location like I am back home.
Which steps can I take on the routers to prevent or minimize this, or there is always a chance?
Hi everyone,
Prior to a trip abroad, about a month ago, I got my NAS to work as an Exit Node - which on itself was an achievement - but because I was at home, after I tested the access during park strolls, I didn't care more about it.
The trip is now live and I am unable to use the NAS as an Exit Node, although the device is connected, advertised as an Exit Node, etc., etc., but when I connect, I have no internet.
Any thoughts on what I can do?
I am running the Official Tailscale (the container one / dark icon).
For those who opened their G4 and noticed that melted/burned like, on the soldered wifi card, did you end up keeping it? Mine is the same but both the WIFI and BT are working as it should - for now.
(another user as reference - mine is not as bad - https://www.reddit.com/r/MiniPCs/comments/1dvemqm/trigkey_g4_n100_this_doesnt_look_good_right/ )
These G4 compared to my Trigkey S5 and a couple of Firebat T8 Plus, seem to be a lot less pleasant with the fan noise.