u/nalyd39

Ok, I posted earlier about this issue but have some time to sit and really give evidence now. I keep getting an error for failure to extrude.

When I first saw the error my original thought was extruder jam but to run a cold pull and that would tell me if the extruder wasn't working or if it was just a clogged nozzle. The cold pull worked and showed clean. Ok move on. Tried to print the job again and get the same error.

Ive now done 3 or 4 cold pulls, attempted to remove the extruder which lead to stripping the screw that holds the filament cutter in place, manually ran filament through the extruder without a nozzle attached, everything seems just fine but I get the error every time it tries to load filament for a job. I can physically watch the filament go all the way to the toolhead through the ptfe tube but it refuses to extrude it.

I have additional photo/video evidence of the extruder working fine but can't attach more than one so here is a cold pull that was done just a minute ago.

Completely new to this but i bought an X2D last week. Its been running mostly fine with the occasional hiccup but now I can't figure out what is going on. Ive ran a few successful cold pulls and yet every time I got to print I get an error stating it has failed to extrude the filament

I dont see how the two are possible, I'm watching the filament enter the print head and a cold pull gives me a successful extrude. Any suggestions? I even changed out to my spare nozzle and still having the issue