u/prosequare

I’ve been using this comgrow arcticgrip aurora plate for a few weeks now with pla and petg. So far all the prints have turned out great and adhesion has been perfect. But last night we had a power outage at 25% of this print (and again at 70%). My p1s was able to resume the print each time, but once it finished I was left with this.

Creality petg, bed 70, all layers 255, using generic petg profile in bambu studio. I’ve already printed most of this roll of petg on this plate without issue.

Wondering if the reheating caused this or if this plate brand was junk to begin with.

Edit: thanks for the info, I’ll try a different brand next time and use glue for petg.

Designed and printed this case to accommodate a Heltec v4, a gps unit, and a substantial battery (10000mah). Based on readings from my rooftop node, reception isn’t terribly affected by the placement of the (already excellent muzi) antenna. EMI from inside the house overpowered any real difference among several nodes’ rssi.
Filament is panchroma army olive green, matte. Screws are m3x10mm. Not visible is a ble pcb patch antenna inside the enclosure. GPS is under the grille. Not sure if it made a difference, but it has acquired 9 satellites sitting in my living room.