u/radicalfrenz

I go by radfrenzfb and radfrenzfingerboards on Instagram and I specialize in splits. This is what I currently have in stock. If interested you can reach me through messages here or on Instagram at the first two handles I mentioned.

First pic of Reapers are 34mm
Second pic of decks is also 34mm.
Third pic are all 32mm.
Fourth pick is one 36mm and one 29mm.

Everything is HANDCUT. No lasers or similar type of machines were involved in making these.

Haven’t been Fingerboarding too much lately cause of my summer job. Thankfully that’s over and I have more time to FB and make decks! Check out my insta accounts radfrenzfb and radfrenzfingerboards for more content.

Just barely started getting switch heels into grinds, slowly getting them but want it to look more fluid and clean. Doing switch heels outta grinds is way easier for sure.

I go by RadFrenzfb/Radfrenzfingerboards on Instagram and been making decks for going on about 5 years. I use to run a Skateshop called Red Curbs in the Bay Area and used my free time there to learn how to make fingerboards. I also host and help set up FB events with a bunch of different makers in the Bay Area. I mainly try to specialize in split plies (inlay marquetry) for my decks but I dabble in a little of everything. All the split plies are also hand cut, no lasers or circuits involved in getting the image. Reach out through messages here or on insta if anyone is interested in grabbing one. Appreciate you all

I had an event at the end of the month last month. These are all the boards I have left that’s available. If anyone is interested reach out through messages here or on Instagram at radfrenzfingerboards. Mainly 32mm and 34mm.

All splits are %100 hand cut. No lasers involved

Updated flyer with new sponsors. Check out my insta Radfrenzfb for more details and info about the event.

May 30th 12-6 at Newark Skatepark in Newark, CA.