u/scubadivertie

Hello all,

I just got this new Comgrow PEI Sheet Magnetic Flexible Heated Bed, PEI Spring Steel 235x235mm

For my Ender 3 V2 running Marlin 2.1.3 MRiscoC, CREALITY New Sprite Extruder Pro, CRTouch

I did a print on it and it worked perfectly with SUNLU PLA+ WHITE, but I have tried 3 prints after and I can't get it to stay stuck to the plate.

I haven't changed any of the settings, I have washed it with Dawn and 91% ISO

Bed is set to 60, nozzle is set to 210,

I ran the tram wizard and redid the mesh leveling before each print after the first failed print.

What suggestions do you have

Can someone tell me what is causing this? The print was going fine when I went to bed last night and I woke up to this was happening. Any advice?

Hello all

I just installed the Sprite Pro and CR Touch on my ender 3 v2.

​

I have tried repluging in all the cables on the mother board, made sure they are all seated, tried updating the firmware from creality and Mriscoc multiple times, I have formatted the SD card multiple times, tried calling the firmware file: firmware.bin, ender3v2.bin, 123.bin, and firmware1.bin. yes I did format my SD card as FAT32 and it is an 8gb card that was working in the printer before I installed the Sprite Pro and CR Touch. Please help any and all advice is greatly appreciated

What could be causing this blob while printing?

This is my 4th or 5th test print

Settings our

1st layer temp 200

Other layers temp 200

Idle temp 150

Bed temp 60

Speed 100%

Retraction 10mm

Just got my printer and this is my first benchy

Any and all advice welcome