u/semeoneor

▲ 1 r/CT200h

Coolant cap tightness

2017 ct200 over 200k (odometer rollback) on long idles then startup misfires and consumes coolant over the week

Does loosening radiator cap release pressure to stop startup misfires? While warranty company and shop fights over replacing engine?

reddit.com
u/semeoneor — 1 day ago
▲ 2 r/CT200h

Best places to sell vehicle parts nowadays

I m going sell the oem 17 wheels what places have the most activity nowadays?

reddit.com
u/semeoneor — 7 days ago
▲ 3 r/CT200h

Oem plugs

Anyone ever notice anything odd using non oem plugs ive noticed since ive owned car its never had oem plugs installed always champion or skp at proper gap wondering if using oem plugs would solve a misfire at low rpm that never goes away after maintenance things

reddit.com
u/semeoneor — 26 days ago
▲ 5 r/CT200h

Misfire @ low rpm (1350) death rattle none of the common issues

I have a 17 with unknown mileage due to odometer fraud but over 200k new plugs new coils new egr stuff cooler pipe etc misfires at idle rpm or 1300 not burning any coolant in the last few months

Is there any other things to check or should I use this as a excuse to do a gen 4 engine swap?

Would fuel Injectors misfire randomly at idle and run fine when moving? Or do headgaskets fail other than burning coolant?

reddit.com
u/semeoneor — 28 days ago
▲ 1 r/CT200h

Longtime misfire cyl2

This car has always done quick death rattles on start ups now its rattling a lot until rpm goes above idle

New plugs coils verified stock gap .44 still rattling, egr parts cleaned , passed headgasket test and engine coolant and inverter coolant remains full after cooldown

Im thinking the injector is bad swapped it to cyl 3 misfire goes to cyl 3 ; swapped 3 to 4 misfire stays on cyl 3 now but I scrapped some gunk out of cyl 2 valves in cylinder head so im thinking I need to have the head cleaned the plastic manifold is already cleaned

Can I just get a brush on a drill spray some cleaner In head and vaccum the black gunk out cylinder car is odometer rollback victim so assume mileage is over 200k

Also is the half o ring on tip of injector important ? Two were missing it

u/semeoneor — 1 month ago
▲ 9 r/CT200h

On today's episode of did it fit

6ftx 12 in wide had to sit on armrest

u/semeoneor — 1 month ago
▲ 5 r/CT200h

Macguyver find of the day

We was on a lift trying to figure out why this odometer rollback stealership special has a exhaust leak from lower egr bolt turns out its missing and this thing is on the top one

u/semeoneor — 2 months ago
▲ 2 r/CT200h

Floormats ux250h fitment

Since the successor to the ct200 has similar rear legroom does the all weather floormats fit near perfectly? I notice theres a lot of cheap new unsold all weather floormats for the newer car

u/semeoneor — 2 months ago
▲ 1 r/CT200h

Seat covers or junkyard seats

These seats are doing that wrinkle never cared for thing is it nowadays cheaper to find temu aliexpress seat cover replacements ( I see a zipper on seats) or go junkyard hopping for rare color combos

reddit.com
u/semeoneor — 3 months ago
▲ 46 r/CT200h

On today's episode of will it fit

Yes Bathtub bottom 5ft long

u/semeoneor — 3 months ago
▲ 7 r/CT200h

Recently headunit options

Has anyone recently purchased and have experience with any China based head units recently ? Im trying to find a unit that matches the higher end aftermarket pioneer double dins I have to run the extra focal components & 1600w 5 channel / 1600w mono amp i have im storage

I've attached images of the 100$ unit im using now to replace factory but saw a tesla 9 inch looking model also since this 100 $ model is missing some features to customize adjust audio specs

The first photo im using now has android 15

u/semeoneor — 3 months ago
▲ 2 r/CT200h

Gen 5 swap

Anyone knows if gen 5 engine swaps in ct is see gen 4 swaps and ive been told gen 5 is gen 4 with improvements

reddit.com
u/semeoneor — 3 months ago