u/tolebelon

So at one of my ranges they have a .44 for rent. I’ve hung around long enough and seen enough people use it to notice that it pretty simply does not run.

I did some slow mo on someone renting it to see what was happening. Tldr, it looks like it cant pull the case out, and the extractor slips off. Doesn’t matter if you’re limp wristing or clamping it down like John Wick.

It gets rented out pretty frequently but the range staff will usually say just single load it. Any ideas on what could help remedy it? Occasionally it will succeed in extracting and cycling but not often.

Shush child, we have PPsH at home.

——
Based on the PPsH kit from iHitCircles.
Printed an extra middle section as my barrel is 18 inches vs the 16 in the original design. Even then it pokes out a bit.

All printed using Elegoo PLA +.
Dummy mag extension is my design and I’ll post that up somewhere when I find a glue that is strong enough.